enbgde
P0425 Generic (SAE) Basic entry

Catalyst Temperature Sensor

Updated 2026-10-02 · Auxiliary emission controls

Severity
Medium
Typical repair cost
60 – 500 EUR
System
Powertrain

What it means

P0425 is defined as "Catalyst Temperature Sensor". the engine control module stores it when the monitored condition for this component or system is outside the limits programmed by the manufacturer.

This entry is compiled automatically from the standard definition and typical diagnostic practice for this type of fault. A detailed, reviewed article is in preparation.

Advertisement728 × 90

Symptoms

  • Check engine light on, often with no change in driveability
  • Failed emissions inspection
  • Slight increase in fuel consumption
  • Smell from the exhaust in some cases

Common causes

  1. Catalyst Temperature Sensor worn, contaminated or out of calibration
  2. Mechanical problem in the system the sensor measures
  3. Air, vacuum or exhaust leak influencing the reading
  4. Wrong or low-quality replacement part
  5. Wiring resistance causing a small voltage offset

How to diagnose

  1. Compare the live Catalyst Temperature Sensor reading with a known-good value or a second sensor at idle and at 2500 rpm
  2. Check for air, vacuum or exhaust leaks that could skew the reading
  3. Inspect the component for contamination and clean it if the design allows
  4. Verify the part number is correct for the engine
  5. Replace the Catalyst Temperature Sensor if the reading remains out of specification

Frequently asked questions

Can I keep driving with P0425?

Usually yes for a short time, but expect reduced performance or higher fuel use. Have it diagnosed within a few days.

Will clearing P0425 fix it?

No. Clearing only erases the stored code; it returns as soon as the monitor runs again unless the cause is repaired.

Related codes

P0435

Nearby codes in this group