enbgde
P0466 Generic (SAE) Basic entry

EVAP Purge Flow Sensor Circuit Range/Performance

Updated 2026-10-02 · Auxiliary emission controls

Severity
Low
Typical repair cost
60 – 500 EUR
System
Powertrain

What it means

P0466 is stored when the EVAP Purge Flow signal is electrically valid but does not make sense compared with other sensors or the expected operating range. The circuit is usually fine; the component or what it measures is out of specification.

This entry is compiled automatically from the standard definition and typical diagnostic practice for this type of fault. A detailed, reviewed article is in preparation.

Advertisement728 × 90

Symptoms

  • Check engine light on, often with no change in driveability
  • Failed emissions inspection
  • Slight increase in fuel consumption
  • Smell from the exhaust in some cases

Common causes

  1. EVAP Purge Flow worn, contaminated or out of calibration
  2. Mechanical problem in the system the sensor measures
  3. Air, vacuum or exhaust leak influencing the reading
  4. Wrong or low-quality replacement part
  5. Wiring resistance causing a small voltage offset

How to diagnose

  1. Compare the live EVAP Purge Flow reading with a known-good value or a second sensor at idle and at 2500 rpm
  2. Check for air, vacuum or exhaust leaks that could skew the reading
  3. Inspect the component for contamination and clean it if the design allows
  4. Verify the part number is correct for the engine
  5. Replace the EVAP Purge Flow if the reading remains out of specification

Frequently asked questions

Can I keep driving with P0466?

Yes. The fault does not affect safety or driveability, but it will keep the warning light on and may fail an inspection.

Will clearing P0466 fix it?

No. Clearing only erases the stored code; it returns as soon as the monitor runs again unless the cause is repaired.

Related codes

P0467P0468P0469

Nearby codes in this group