P0704
Generic (SAE) Basic entry
Clutch Switch Input Circuit Malfunction
Severity
Medium
Typical repair cost
40 – 350 EUR
System
Powertrain
What it means
P0704 is a general fault for the Clutch Switch Input circuit: the engine control module has detected a condition it cannot classify as low, high or open, often because the fault changes during the test.
Advertisement728 × 90
Symptoms
- Check engine or transmission warning light
- Harsh, delayed or missing shifts
- Transmission stuck in one gear (limp mode)
- Shuddering or slipping under load
Common causes
- Damaged, chafed or corroded wiring in the Clutch Switch Input circuit
- Corroded, loose or water-damaged connector terminals
- Failed Clutch Switch Input component (sensor, solenoid or actuator)
- Poor ground connection for the module or component
- Faulty control module driver (rare, confirm all else first)
How to diagnose
- Read freeze frame data and note when the code set (cold start, under load, after rain)
- Inspect the Clutch Switch Input connector for bent pins, corrosion and water; wiggle the harness with the engine running and watch live data
- Measure supply voltage and ground at the connector with the key on
- Check the signal wire for shorts to ground or battery and for continuity to the control module
- Test or substitute the Clutch Switch Input only after wiring and connectors are confirmed good
- Clear the code and complete a drive cycle to confirm the repair
Frequently asked questions
Can I keep driving with P0704?
Usually yes for a short time, but expect reduced performance or higher fuel use. Have it diagnosed within a few days.
Will clearing P0704 fix it?
No. Clearing only erases the stored code; it returns as soon as the monitor runs again unless the cause is repaired.
Symptoms linked to this code
Terms to know
Related codes
Nearby codes in this group
- P0703Brake Switch 'B' Circuit
- P0705Transmission Range Sensor Circuit Malfunction (PRNDL Input)
- P0702Transmission Control System Electrical
- P0706Transmission Range Sensor Circuit Range/Performance
- P0701Transmission Control System Range/Performance
- P0707Transmission Range Sensor Circuit Low
- P0700Transmission Control System (MIL Request)
- P0708Transmission Range Sensor Circuit High