P0807
Generic (SAE) Basic entry
Clutch Position Sensor Circuit Low
Severity
Medium
Typical repair cost
40 – 350 EUR
System
Powertrain
What it means
P0807 is stored when the engine control module measures a voltage in the Clutch Position circuit that stays below the expected minimum. In practice this points to a short to ground, a damaged wire or a failed component rather than a mechanical problem.
Advertisement728 × 90
Symptoms
- Check engine or transmission warning light
- Harsh, delayed or missing shifts
- Transmission stuck in one gear (limp mode)
- Shuddering or slipping under load
Common causes
- Damaged, chafed or corroded wiring in the Clutch Position circuit
- Corroded, loose or water-damaged connector terminals
- Failed Clutch Position component (sensor, solenoid or actuator)
- Poor ground connection for the module or component
- Faulty control module driver (rare, confirm all else first)
How to diagnose
- Read freeze frame data and note when the code set (cold start, under load, after rain)
- Inspect the Clutch Position connector for bent pins, corrosion and water; wiggle the harness with the engine running and watch live data
- Measure supply voltage and ground at the connector with the key on
- Check the signal wire for shorts to ground or battery and for continuity to the control module
- Test or substitute the Clutch Position only after wiring and connectors are confirmed good
- Clear the code and complete a drive cycle to confirm the repair
Frequently asked questions
Can I keep driving with P0807?
Usually yes for a short time, but expect reduced performance or higher fuel use. Have it diagnosed within a few days.
Will clearing P0807 fix it?
No. Clearing only erases the stored code; it returns as soon as the monitor runs again unless the cause is repaired.
Symptoms linked to this code
Terms to know
Related codes
Nearby codes in this group
- P0806Clutch Position Sensor Circuit Range/Performance
- P0808Clutch Position Sensor Circuit High
- P0805Clutch Position Sensor Circuit
- P0809Clutch Position Sensor Circuit Intermittent
- P08041-4 Upshift (Skip Shift) Lamp Control Circuit
- P0810Clutch Position Control Error
- P08031-4 Upshift (Skip Shift) Solenoid Control Circuit
- P0811Excessive Clutch Slippage