P0885
Generic (SAE) Basic entry
TCM Power Relay Control Circuit/Open
Severity
Medium
Typical repair cost
40 – 350 EUR
System
Powertrain
What it means
P0885 means the engine control module cannot detect current flow in the TCM Power Relay Control Circuit circuit: the circuit is electrically open somewhere between the module, the connector and the component.
Advertisement728 × 90
Symptoms
- Check engine or transmission warning light
- Harsh, delayed or missing shifts
- Transmission stuck in one gear (limp mode)
- Shuddering or slipping under load
Common causes
- Damaged, chafed or corroded wiring in the TCM Power Relay Control Circuit circuit
- Corroded, loose or water-damaged connector terminals
- Failed TCM Power Relay Control Circuit component (sensor, solenoid or actuator)
- Poor ground connection for the module or component
- Faulty control module driver (rare, confirm all else first)
How to diagnose
- Read freeze frame data and note when the code set (cold start, under load, after rain)
- Inspect the TCM Power Relay Control Circuit connector for bent pins, corrosion and water; wiggle the harness with the engine running and watch live data
- Measure supply voltage and ground at the connector with the key on
- Check the signal wire for shorts to ground or battery and for continuity to the control module
- Test or substitute the TCM Power Relay Control Circuit only after wiring and connectors are confirmed good
- Clear the code and complete a drive cycle to confirm the repair
Frequently asked questions
Can I keep driving with P0885?
Usually yes for a short time, but expect reduced performance or higher fuel use. Have it diagnosed within a few days.
Will clearing P0885 fix it?
No. Clearing only erases the stored code; it returns as soon as the monitor runs again unless the cause is repaired.
Related codes
Nearby codes in this group
- P0884TCM Power Input Signal Intermittent
- P0886TCM Power Relay Control Circuit Low
- P0883TCM Power Input Signal High
- P0887TCM Power Relay Control Circuit High
- P0882TCM Power Input Signal Low
- P0888TCM Power Relay Sense Circuit
- P0881TCM Power Input Signal Range/Performance
- P0889TCM Power Relay Sense Circuit Range/Performance