P0936 Generic (SAE) Basic entry

Hydraulic Pressure Sensor Circuit Intermittent

Updated 2026-10-02 · Transmission

Severity

Medium

Typical repair cost

40 – 350 EUR

System

Powertrain

What it means

P0936 is stored when the Hydraulic Pressure signal drops out or jumps erratically for short periods. Intermittent faults are almost always connector, wiring or vibration related.

This entry is compiled automatically from the standard definition and typical diagnostic practice for this type of fault. A detailed, reviewed article is in preparation.

Advertisement728 × 90

Symptoms

Check engine or transmission warning light
Harsh, delayed or missing shifts
Transmission stuck in one gear (limp mode)
Shuddering or slipping under load

Common causes

Damaged, chafed or corroded wiring in the Hydraulic Pressure circuit
Corroded, loose or water-damaged connector terminals
Failed Hydraulic Pressure component (sensor, solenoid or actuator)
Poor ground connection for the module or component
Faulty control module driver (rare, confirm all else first)

How to diagnose

Read freeze frame data and note when the code set (cold start, under load, after rain)
Inspect the Hydraulic Pressure connector for bent pins, corrosion and water; wiggle the harness with the engine running and watch live data
Measure supply voltage and ground at the connector with the key on
Check the signal wire for shorts to ground or battery and for continuity to the control module
Test or substitute the Hydraulic Pressure only after wiring and connectors are confirmed good
Clear the code and complete a drive cycle to confirm the repair

Frequently asked questions

Can I keep driving with P0936?

Usually yes for a short time, but expect reduced performance or higher fuel use. Have it diagnosed within a few days.

Will clearing P0936 fix it?

No. Clearing only erases the stored code; it returns as soon as the monitor runs again unless the cause is repaired.

Related codes

P0933 P0934 P0935