P1349
Manufacturer-specific Basic entry
Camshaft Position Sensor B Range / Performance
Severity
Medium
Typical repair cost
60 – 500 EUR
System
Powertrain
This is a manufacturer-specific code. Its exact meaning can differ between makes; the definition below follows the most common usage.
What it means
P1349 is stored when the Camshaft Position Sensor B Range signal is electrically valid but does not make sense compared with other sensors or the expected operating range. The circuit is usually fine; the component or what it measures is out of specification.
Advertisement728 × 90
Symptoms
- Check engine light on
- Rough or unstable idle
- Hesitation or poor acceleration
- Increased fuel consumption
- Possible limp mode with reduced power
Common causes
- Camshaft Position Sensor B Range worn, contaminated or out of calibration
- Mechanical problem in the system the sensor measures
- Air, vacuum or exhaust leak influencing the reading
- Wrong or low-quality replacement part
- Wiring resistance causing a small voltage offset
How to diagnose
- Compare the live Camshaft Position Sensor B Range reading with a known-good value or a second sensor at idle and at 2500 rpm
- Check for air, vacuum or exhaust leaks that could skew the reading
- Inspect the component for contamination and clean it if the design allows
- Verify the part number is correct for the engine
- Replace the Camshaft Position Sensor B Range if the reading remains out of specification
Frequently asked questions
Can I keep driving with P1349?
Usually yes for a short time, but expect reduced performance or higher fuel use. Have it diagnosed within a few days.
Will clearing P1349 fix it?
No. Clearing only erases the stored code; it returns as soon as the monitor runs again unless the cause is repaired.
Related codes
Nearby codes in this group
- P1348Camshaft Position Sensor B Circuit Malfunction
- P1350SGC (Cam Position) Sensor Circuit Malfunction/ Crankshaft Position - Camshaft Position Correlation
- P1347Crank / Cam Sensor Range / Performance
- P1351Fuel Level Sensor B Circuit Malfunction
- P1346Injector Circuit / IDM Codes Not Updated
- P1352Fuel Level Sensor B Range / Performance
- P1345Injector Circuit / IDM Codes Detected
- P1353Fuel Level Sensor B Circuit Low