enbgde
P1445 Manufacturer-specific Basic entry

Evaporative Emission (EVAP) System Flow During Non-Purge Chevrolet Only

Updated 2026-10-02 · Manufacturer-specific powertrain

Severity
Low
Typical repair cost
60 – 500 EUR
System
Powertrain

This is a manufacturer-specific code. Its exact meaning can differ between makes; the definition below follows the most common usage.

What it means

P1445 is defined as "Evaporative Emission (EVAP) System Flow During Non-Purge Chevrolet Only". the engine control module stores it when the monitored condition for this component or system is outside the limits programmed by the manufacturer.

This entry is compiled automatically from the standard definition and typical diagnostic practice for this type of fault. A detailed, reviewed article is in preparation.

Advertisement728 × 90

Symptoms

  • Check engine light on
  • Rough or unstable idle
  • Hesitation or poor acceleration
  • Increased fuel consumption
  • Possible limp mode with reduced power

Common causes

  1. Evaporative Emission (EVAP) System Flow During Non-Purge Chevrolet Only worn, contaminated or out of calibration
  2. Mechanical problem in the system the sensor measures
  3. Air, vacuum or exhaust leak influencing the reading
  4. Wrong or low-quality replacement part
  5. Wiring resistance causing a small voltage offset

How to diagnose

  1. Compare the live Evaporative Emission (EVAP) System Flow During Non-Purge Chevrolet Only reading with a known-good value or a second sensor at idle and at 2500 rpm
  2. Check for air, vacuum or exhaust leaks that could skew the reading
  3. Inspect the component for contamination and clean it if the design allows
  4. Verify the part number is correct for the engine
  5. Replace the Evaporative Emission (EVAP) System Flow During Non-Purge Chevrolet Only if the reading remains out of specification

Frequently asked questions

Can I keep driving with P1445?

Yes. The fault does not affect safety or driveability, but it will keep the warning light on and may fail an inspection.

Will clearing P1445 fix it?

No. Clearing only erases the stored code; it returns as soon as the monitor runs again unless the cause is repaired.

Related codes

P1443P1444P1446P1447

Nearby codes in this group