P2136 Generic (SAE) Basic entry

Throttle/Pedal Position Sensor/Switch 'A' / 'C' Voltage Correlation

Updated 2026-10-02 · Fuel, air & emissions (P2)

Severity
Medium
Typical repair cost
60 – 500 EUR
System
Powertrain

What it means

P2136 is defined as "Throttle/Pedal Position Sensor/Switch 'A' / 'C' Voltage Correlation". the engine control module stores it when the monitored condition for this component or system is outside the limits programmed by the manufacturer.

This entry is compiled automatically from the standard definition and typical diagnostic practice for this type of fault. A detailed, reviewed article is in preparation.

Advertisement728 × 90

Symptoms

  • Check engine light on
  • Rough or unstable idle
  • Hesitation or poor acceleration
  • Increased fuel consumption
  • Possible limp mode with reduced power

Common causes

  1. Throttle/Pedal Position Sensor/Switch 'A' / 'C' Voltage Correlation worn, contaminated or out of calibration
  2. Mechanical problem in the system the sensor measures
  3. Air, vacuum or exhaust leak influencing the reading
  4. Wrong or low-quality replacement part
  5. Wiring resistance causing a small voltage offset

How to diagnose

  1. Compare the live Throttle/Pedal Position Sensor/Switch 'A' / 'C' Voltage Correlation reading with a known-good value or a second sensor at idle and at 2500 rpm
  2. Check for air, vacuum or exhaust leaks that could skew the reading
  3. Inspect the component for contamination and clean it if the design allows
  4. Verify the part number is correct for the engine
  5. Replace the Throttle/Pedal Position Sensor/Switch 'A' / 'C' Voltage Correlation if the reading remains out of specification

Frequently asked questions

Can I keep driving with P2136?

Usually yes for a short time, but expect reduced performance or higher fuel use. Have it diagnosed within a few days.

Will clearing P2136 fix it?

No. Clearing only erases the stored code; it returns as soon as the monitor runs again unless the cause is repaired.