enbgde
P2513 Generic (SAE) Basic entry

Event Data Recorder Request Circuit Low

Updated 2026-10-02 · Fuel, air & emissions (P2)

Severity
Low
Typical repair cost
40 – 350 EUR
System
Powertrain

What it means

P2513 is stored when the engine control module measures a voltage in the Event Data Recorder Request circuit that stays below the expected minimum. In practice this points to a short to ground, a damaged wire or a failed component rather than a mechanical problem.

This entry is compiled automatically from the standard definition and typical diagnostic practice for this type of fault. A detailed, reviewed article is in preparation.

Advertisement728 × 90

Symptoms

  • Check engine light on
  • Rough or unstable idle
  • Hesitation or poor acceleration
  • Increased fuel consumption
  • Possible limp mode with reduced power

Common causes

  1. Damaged, chafed or corroded wiring in the Event Data Recorder Request circuit
  2. Corroded, loose or water-damaged connector terminals
  3. Failed Event Data Recorder Request component (sensor, solenoid or actuator)
  4. Poor ground connection for the module or component
  5. Faulty control module driver (rare, confirm all else first)

How to diagnose

  1. Read freeze frame data and note when the code set (cold start, under load, after rain)
  2. Inspect the Event Data Recorder Request connector for bent pins, corrosion and water; wiggle the harness with the engine running and watch live data
  3. Measure supply voltage and ground at the connector with the key on
  4. Check the signal wire for shorts to ground or battery and for continuity to the control module
  5. Test or substitute the Event Data Recorder Request only after wiring and connectors are confirmed good
  6. Clear the code and complete a drive cycle to confirm the repair

Frequently asked questions

Can I keep driving with P2513?

Yes. The fault does not affect safety or driveability, but it will keep the warning light on and may fail an inspection.

Will clearing P2513 fix it?

No. Clearing only erases the stored code; it returns as soon as the monitor runs again unless the cause is repaired.

Related codes

P2514

Nearby codes in this group