enbgde
P2552 Generic (SAE) Basic entry

Throttle/Fuel Inhibit Circuit

Updated 2026-10-02 · Fuel, air & emissions (P2)

Severity
Medium
Typical repair cost
60 – 500 EUR
System
Powertrain

What it means

P2552 is defined as "Throttle/Fuel Inhibit Circuit". the engine control module stores it when the monitored condition for this component or system is outside the limits programmed by the manufacturer.

This entry is compiled automatically from the standard definition and typical diagnostic practice for this type of fault. A detailed, reviewed article is in preparation.

Advertisement728 × 90

Symptoms

  • Check engine light on
  • Rough or unstable idle
  • Hesitation or poor acceleration
  • Increased fuel consumption
  • Possible limp mode with reduced power

Common causes

  1. Throttle/Fuel Inhibit Circuit worn, contaminated or out of calibration
  2. Mechanical problem in the system the sensor measures
  3. Air, vacuum or exhaust leak influencing the reading
  4. Wrong or low-quality replacement part
  5. Wiring resistance causing a small voltage offset

How to diagnose

  1. Compare the live Throttle/Fuel Inhibit Circuit reading with a known-good value or a second sensor at idle and at 2500 rpm
  2. Check for air, vacuum or exhaust leaks that could skew the reading
  3. Inspect the component for contamination and clean it if the design allows
  4. Verify the part number is correct for the engine
  5. Replace the Throttle/Fuel Inhibit Circuit if the reading remains out of specification

Frequently asked questions

Can I keep driving with P2552?

Usually yes for a short time, but expect reduced performance or higher fuel use. Have it diagnosed within a few days.

Will clearing P2552 fix it?

No. Clearing only erases the stored code; it returns as soon as the monitor runs again unless the cause is repaired.

Related codes

P2550P2551P2553P2554

Nearby codes in this group